Free tool · About 25 seconds
Bufferbloat test
Calls fine until someone uploads a video? That’s bufferbloat. This test measures latency at rest and with the line full, both ways.
Latency, ms · Ready
Uses up to about 350 MB. Don’t run it on a metered hotspot.
Fix bufferbloat at the router.
- Turn on smart queue management.Look for SQM, Smart Queue, QoS, fq_codel or CAKE in the router’s settings. Set it to about 90% of your measured speeds.
- Test again.The latency rise under load should drop to tens of milliseconds. If not, lower the limits a little.
- Check the router guide.The router guides show where QoS lives on common models, and which have no SQM.
- Move big uploads.Cloud backups and photo uploads fill the upload side. Schedule them for when nobody’s on a call.
Measure it from Terminal.
# Apple’s responsiveness test, built into macOS
networkQuality -v
# Periodic latency spikes, with Kilobat
kilobat stutterMore checks for your connection.
- Ping testMedian latency, jitter, and a plain answer for calls and games.
- Speed checkerYour speed tests against your plan and your country’s rules on slow internet.
- What is my IP?Your public IPv4 and IPv6 addresses, your provider and roughly where websites think you are.
- CGNAT checkIs your provider sharing one public address between customers? Compare it with your router’s.
Privacy and VPN
Speed and latency
- Ping test
- Bufferbloat test
- Speed checker
Your network
Calculators
Claims and evidence
Questions
What is bufferbloat?
When a download or upload fills your connection, the router or modem queues packets in large buffers. Everything else waits in that queue. Latency jumps from tens to hundreds of milliseconds, and calls and games stutter.
How does this test work?
It times small requests to Cloudflare’s nearest data centre for five seconds at rest. Then it repeats while downloading for ten seconds, and while uploading for ten. The rise in latency under load is the bufferbloat.
What is a good result?
Under 30 ms extra under load is good: calls and games stay smooth. 30 to 100 ms is noticeable. Over 100 ms means calls break up whenever someone downloads or uploads.
How do I fix bufferbloat?
Turn on smart queue management (SQM) on the router, often called QoS, Smart Queue or fq_codel/CAKE. Set it a little below your real speeds. If the router can’t, a router that supports it usually fixes it.
How much data does the test use?
Up to about 350 MB on a fast line, and less on a slow one. Don’t run it on a metered hotspot or travel eSIM.
Is there a test built into macOS?
Yes. networkQuality in Terminal measures responsiveness under load in round trips per minute (RPM). Higher is better.
Can Kilobat watch for this?
Kilobat’s stutter test finds periodic latency spikes, and Real-time quality in Health rates calls, gaming and streaming. Run kilobat stutter in Terminal. Kilobat is free; Pro is $29 once.
Sources
- Cloudflare: speed test
- RFC 8290: The Flow Queue CoDel Packet Scheduler and Active Queue Management Algorithm
- IETF: Responsiveness under Working Conditions
- Apple Support: Test your network’s responsiveness (networkQuality)
- Bufferbloat.net: What can I do about bufferbloat?
Checked on 7 November 2026.
Find what makes your calls and games lag.
brew install seifip/kilobat/kilobat